VooPoo Drag 6 could use what kind e-liquid and how to use

The VooPoo Drag 6 uses the PnP X Coil platform. The specific type of e-liquid you need depends directly on the coil resistance (ohms) installed in the tank.

E-Liquid Selection Guide

• Freebase E-Liquid (High VG: 70/30 VG/PG ratio):
  • Best for: Low-resistance sub-ohm coils (0.15 Ω, 0.2 Ω, 0.3 Ω).
  • Nicotine Strength: Low nicotine levels (0 mg, 3 mg, or 6 mg). High-wattage direct-to-lung (DTL) vaping produces large vapor clouds, making high nicotine concentrations far too harsh.
• Nicotine Salts or Balanced E-Liquid (50/50 VG/PG ratio):
  • Best for: Higher-resistance coils (0.6 Ω, 0.8 Ω, 1.0 Ω).
  • Nicotine Strength: Medium to high nicotine levels (10 mg – 20 mg+). These are designed for mouth-to-lung (MTL) or restricted direct-to-lung (RDL) lower-wattage vaping.

How to Use the VooPoo Drag 6

• 1. Install the Coil & Fill the Tank
  • Push your selected PnP X coil firmly into the base of the tank.
  • Open the top-fill cap on the UFORCE-X Tank II. Fill with e-liquid up to ~80% capacity and seal it tight.
  • Crucial Step: Wait 5 to 10 minutes before your first puff to allow the cotton inside the coil to saturate fully with liquid (prevents dry hits and coil burning).
• 2. Power On & Adjust Settings
  • Power On/Off: Click the main fire button 5 times quickly.
  • Set Wattage: Adjust the power output according to the recommended wattage printed right on the side of your coil (e.g., 60–80W for a 0.15 Ω coil).
• 3. Adjust Airflow & Unlock
  • Rotate the top airflow ring on the tank to customize your draw preference (tight vs. loose).
  • Touch or double-tap the capacitive unlock sensor to unlock the touch screen, press the fire button, and inhale.